Setup; Installation; Firmware Updates - Hall Technologies LYNX Series Manual

Setup

INSTALLATION

Note: Before installation, please ensure the devices are disconnected from the power source.
To install the device on a surface:
1. Secure the included L-bracket mounts to each side of the transmitter/receiver using the
included screws.
2. The bottom part of the L-bracket should be flush with the bottom of the transmitter/receiver.
3. Using the appropriate hardware (not included), mount the bottom of the L-brackets to the
desired surface.

FIRMWARE UPDATES

1. Locate Tera Term software in the firmware folder, or download it at:
https://osdn.net/projects/ttssh2/releases/
2. Connect the EX-LYNX device to the laptop using a Micro USB cable.
3. Run the Tera Term software
4. Select the correct Serial Port (typically CH340) and then click Ok.
5. Set the serial port connection to have a baud rate of 115200.
6. Go to File, Transfer, YMODEM, and then connect Send.
7. Select the firmware file "xxxxx.bin" then click Open.
8. The upgrade progress bar will show the status of the upgrade.
9. A pop-up window saying "Programming Completed Successfully" when complete.
Hall Technologies December 29, 2022 Page 14 of 18