Applications; Application 1; Scenario 1 Technical Diagram - Hall Technologies LYNX Series Manual

Applications

There are two different application methods with wiring examples shown below each.

APPLICATION 1

This first application uses a transmitter (wall plate or standalone version) to send video to a single
receiver.
A laptop, or other HDMI source, is connected to the HDMI input on the EX-LYNX-TX and then transmitted
over the category cable to the EX-LYNX-RX, where a display, connected to the HDMI output, shows the
HDMI source. A local monitor can be connected to the EX-LYNX-TX HDMI loop-through output. Control
via RS232 or IR is also passed through the category cable for display control.
Note: In this application the EX-LYNX-RX is locally powered and providing power via PoC (Power over
Cable) to the EX-LYNX-TX. Only one side needs to be powered, meaning the local power supply could be
moved to the EX-LYNX-TX if that is more convenient for installation.
Hall Technologies December 29, 2022 Page 11 of 18