Setup; Installation - Hall Technologies FXT-460 User Manual

Setup

INSTALLATION

• On both the FXT-460-S and the FXT-460-R, make sure the SFP modules are fully inserted as they
could have become disconnected during shipping.
• Interconnect the FXT-460-S and FXT-460-R with an LC/PC fiber optic cable.
*Note: Hall Technologies can provide pre-terminated LC fiber optical cable at custom lengths.
You can use single mode or multimode fiber optic cable. Single mode fiber is recommended due
to its 10 km range.
• Optionally, Connect the RS-232 TX, RX, and GND contacts to compatible controllers (e.g., PC or
RS-232 controller).
- Direction of data flow is shown in section below.
- RS-232 passes bi-directionally between the FXT-460-S and FXT-460-R at 115200 baud only.
FXT-460-S
• Optionally, connect an HDMI source to the HDMI IN connector and if desired a HDMI
compatible sink to the HDMI OUT connector.
*Note: A video source is NOT required to embed audio onto the HDMI output at the FXT-460-R.
If no HMDI source signal is present, the HDMI output at the FXT-460-R will be a black screen at
480p resolution.
• Optionally, for audio extraction at transmitter:
- Connect the SPDIF OUT and/or L/R OUT audio outputs to a compatible audio device. (e.g.,
headphones, assistive listening devices, or Audio Amplifier such as the Hall Technologies
AMP-4840 or AMP-7040.)
• Optionally, if you don't want to extend the original HMDI audio:
- Connect the audio to embed to the SPDIF IN and/or L/R IN connector(s).
Hall Technologies August 9, 2023 Page 6 of 13