Application 2 - Hall Technologies LYNX Series Manual

APPLICATION 2

This second application uses a transmitter (wall plate or standalone version) to send video to multiple
receivers, with each receiver cascading off the first receiver.
Similar to the first application, a laptop, or other HDMI source, is connected to the HDMI input on the
EX-LYNX-TX and then transmitted over the category cable to the EX-LYNX-RX, where a display, connected
to the HDMI output, shows the HDMI source. A local monitor can be connected to the EX-LYNX-TX HDMI
loop-through output. Control via RS232 or IR is also passed through the category cable for display control.
A category cable is connected to the output of the first EX-LYNX-RX and connected to the input of the
second EX-LYNX-RX, and up to 8 receivers are connected in a similar manner.
Note: In this application each EX-LYNX-RX needs to be locally powered, and the first EX-LYNX-RX provides
power via PoC (Power over Cable) to the EX-LYNX-TX.
Note: The pass-through control works only on the transmitter to the first receiver.
Hall Technologies December 29, 2022 Page 12 of 18