Advertisement
READ THIS BEFORE INSTALLING 3 wire BNC monitors:
Please follow these simple instructions, to assure a trouble free monitor installation:
Your HP 1097x (Hitachi HM-4419D) monitor like most high-end monitors, requires a
high quality cable to attach to your computer system. This cable is called a BNC
(Bayonet Nut Connect) cable.
Most standard BNC cables have 5 single color-coded wires on the monitor's end,
usually marked as: R (Red), G (Green), B (Blue), H (Horizontal) and V (Vertical).
However, your HP 1097x (Hitachi HM-4419D) monitor requires only 3 color inputs
(Red, Green and Blue, as shown in below illustration) to operate, properly.
If the cable that is supplied with your monitor has 5 individual color-coded wires on the
monitor's end, please connect ONLY the wires that are marked as R, G and B and
leave the H and V wires, unattached. The cable's color codes always match the color
for each video input connector, on the monitor's back.
If your are using the monitor with a PC system:
If a PC video card is supplied with your HP 1097x (Hitachi HM-4419D) monitor, make
sure that the "Sync-On-Green" Jumper (Usually identifiable by a Red Colored Plastic
Jumper on the card) is in Engaged position, as shown in figure 2, below.
Figure 1 – Red
Figure 2 – Red
Jumper
Jumper
Removed
Engaged
Replacement video cards for this monitor can be obtained from: http://fixedfrequency.com
Advertisement
