Advertisement
Table of Contents
Installation Manual For
HITACHI HM-4419D
Color Monitor Series:
®
Hewlett Packard
A1097C/A1O97D
and
®
NCD
19C models
This document contains instructions to connect a Hitachi HM-4419D (HP 1097, NCD 19C,
Cornerstone) color monitor to a PC system, using the accompanying cable and video card.
Please read the documentation provided with the video card, for more instructions.
Advertisement
Table of Contents
Related Manuals for Hitachi HM-4419D
Summary of Contents for Hitachi HM-4419D
- Page 1 ® 19C models This document contains instructions to connect a Hitachi HM-4419D (HP 1097, NCD 19C, Cornerstone) color monitor to a PC system, using the accompanying cable and video card. Please read the documentation provided with the video card, for more instructions.
- Page 2 If your are using the monitor with a PC system: If a PC video card is supplied with your HP 1097x (Hitachi HM-4419D) monitor, make sure that the “Sync-On-Green” Jumper (Usually identifiable by a Red Colored Plastic Jumper on the card) is in Engaged position, as shown in figure 2, below.
- Page 3 If your are using the monitor with a PC system: If a PC video card is supplied with your Hitachi HM-4419D monitor, make sure that the “Sync-On-Green” Jumper (Usually identifiable by a Red Colored Plastic Jumper on the card) is in Removed position, as shown in figure 1, below.
- Page 4 3. HP1097C / HITACHI 4419D’s Back Panel Some may have 3 BNC INPUTS on the back only Attach the 5 video cable: R, G, B, H & V plugs in all 5 connectors in the back of the monitor, as follows: •...
- Page 5 Press the monitor power switch (see illustration below) to ON, and adjust the monitor controls. The brightness control adjusts the brightness of the display The contrast control adjusts the light-to-dark and dark-to-light contrast of the display. The degauss button manually demagnetizes the monitor. Degaussing disperses any accumulated magnetic charge from the face of the monitor.
- Page 6 PC video card. Or if you need to adjust the screen’s height and width for your Hitachi HM- 4419D monitor, please locate the adjustment buttons as shown below, at the lower end portion of the monitor’s back panel (underneath the BNC connectors) and adjust...
- Page 7 80 Hz (not 85 Hz). In this case you need to make sure that you have a Video card with a 7272 or 1097 specification (not 7285, 7285 spec may roll on some Hitachi monitors)
- Page 8 Replacement video cards for this monitor can be obtained from: www.mirage-mmc.com...
Need help?
Do you have a question about the HM-4419D and is the answer not in the manual?
Questions and answers