Control electronics
Control electronics
VTD-60.XX-K5SB
VTD-60.XX-K5SB
5.5 Schematic overview
The USB interface adapter accessory part is not included in the scope of delivery, but is required for commis-
sioning or parametrization using the "epTools" software (see Chapter "8 Accessories" on page 36).
NOTICE
→ Check the pin assignment of your plug (see Chapter "5.3 Electrical installation" on page 23).
→ Connect the built-in connector with the mating connector
NOTICE
→ Ensure that the connector is properly engaged.
①
Schematic overview legend
Position
Designation
①
Motor
②
Control electronics
③
Power supply
④
USB interface adapter
⑤
Computer
5.6 Order of electrical hookup for commissioning
1. Connect control electronics (2) to the USB interface adapter (4).
2. Connect USB interface adapter (4) to the computer (5).
3. Connect motor (1) to the control electronics (2).
4. Connect power supply (3) to the control electronics (2).
③
②
Item no.: HAB 100177146 - 000 · EN · Change· Release 2020-10-26
④
Installation
⑤
27/37