Installation
5.7 Wiring examples
The +U5V pin is used to provide 5 V from the controller for supplying the motor encoders. No external
voltage may be applied to this pin!
If a voltage is applied to the +U5V pin (X2.7 see Chapter "5.3.1 Interfaces" on page 23) on the controller, this
CAUTION
can result in irreparable damage to the device.
5.7.1 EMC-compatible wiring (VTD-XX.13-K5SB)
Item no.: HAB 100177146 - 000 · EN · Change ·Release 2020-10-26
28/37
Heat sink/housing
Control electronics
Control electronics
VTD-60.XX-K5SB
VTD-60.XX-K5SB