Table of Contents
Advertisement
IMPORTANT NOTE:
Do not attempt to lift any load on the upper frame rail. Use
Rubber Lift Blocks only. Rubber Lift Blocks must only be
placed in the receiver trays.
2. With vehicle in ready position, place each jack frame
under the vehicle making sure to position the Rubber
Lift Blocks at the factory recommended jacking points.
Ensure vehicle is positioned with the center-of-balance
placed midway on the jack frames.
TYPICAL JACKING POINTS
Always lift a vehicle according to the manufacturers
recommended lifting points. Typical vehicle jacking points
are illustrated below.
IF THE SPECIFIC VEHICLE LIFT POINTS ARE NOT
IDENTIFIED OR IF THE VEHICLE HAS ADDITIONAL
OR UNIQUELY POSITIONED PAYLOAD, HAVE A
QUALIFIED PERSON CALCULATE THE VEHICLE
CENTER OF GRAVITY OR HAVE THE VEHICLE
CENTER OF GRAVITY DETERMINED AT A VEHICLE
MAKE SURE VEHICLE IS NEITHER FRONT NOR
REAR HEAVY AND SELECT THE PROPER
CONFIGURATION FOR THE VEHICLE TO BE LIFTED
AS SHOWN BELOW. CENTER OF BALANCE SHOULD
BE MIDWAY BETWEEN RUBBER LIFTING BLOCKS
AND CENTERED OVER THE JACK FRAMES.
TO RAISE JACK FRAMES
1. Before raising vehicle, be sure all personnel are clear
of the surrounding area.
18
SCALE.
Advertisement
Table of Contents
