Table of Contents
Advertisement
2. Remove protective shipping plugs from both power
unit ports.
3. Locate both double-male O-ring fittings, then wrap
Teflon tape on pipe threads only - NOT O-RING SIDE.
4. Place one double-male O-ring fitting in the lower
port, with the O-ring facing inward.
5.
Securely tighten fitting.
6.
Install male quick-connect fitting to lower
double-male fitting.
7.
Securely tighten fitting.
8. Repeat same steps for the upper port. Both fittings
should be installed as shown in the images below.
TING COMPONENTS AND CHECK FOR PROPER
12
Advertisement
Table of Contents
