Operation - Titan TTB926STM Instructions Manual

Operation

EN EN
Stripping
WARNING! Check the walls and / or ceilings before operation. If the
material is damaged, loose or seems fragile, consider not using the
product to avoid further damage caused by steam and water.
Test the product on a small area before operation.
1. Place the product on its feet on a flat, stable, heat-resistant surface.
NOTE: Place a suitable element, such as a wooden board, under the
product to avoid marking and / or damaging the surface due to heat
generated by the product.
2. Ensure the water level in the water tank (4) is located between the MIN and
MAX markings and then connect the product to power supply.
3. While the product preheats, score the wallpaper with a suitable tool, such as
a wallpaper scorer or a scraper (7).
WARNING! Wear protective gloves and safety glasses during
operation.
Always grasp the steam plate (3) by its handle (3c) and keep the steam
plate (3) at arms length to avoid burns due to escaping steam.
Do not direct steam towards yourself or others.
4. The product is ready when the water
is boiling and steam escapes from the
steam plate (3). Hold the steam plate by
its handle (3c) and apply to the work area
(Fig. 10).
5. After 10 seconds, move the steam
plate (3) to the area next to the one you
steamed. Use the supplied scraper (7) to
lift / remove the piece of wallpaper you
steamed.
NOTE: If the wallpaper proves difficult to remove, leave the steam
plate (3) a few more seconds on each area.
Alternatively, spray the scored wallpaper with water and let soak for
10 minutes before applying steam.
18
MNL_TTB926STM_2200W Wallpaper Stripper_GB_V8_220623.indd 18 MNL_TTB926STM_2200W Wallpaper Stripper_GB_V8_220623.indd 18
TTB926STM by TITAN
3
3c
Fig. 10
2022/6/23 下午5:04 2022/6/23 下午5:04