Throttle Cable Adjustment; If Your Bike Won't Start - Braaap CRUISER400 User Manual

Throttle cable adjustment

Loosen the lock nut.
Turn the adjuster to adjust the clearance so that the choke lever is in the range
of 5—10mm
Fasten the lock nut again after the adjustment is done.

If your bike won't start

If the engine cannot be started, please make the following checks:
Is there enough fuel in the tank?
You can check fuel levels in the carburetor by draining the bowls by turning
the screws and at the base of each of the bowls.
To check the fuel, tap, and hose, you must remove the side panels directly
under the seat on each side and remove the seat as well. You may also need
to lift the back of the fuel tank to gain access to the fuel cock and the above-
mentioned hose.
The tap should be in the reserve position, I.e, pointing up.
If fuel can get into the carburetor without fail, you should check the ignition
system for spark from spark plug leads by using a spark plug and earthing it
to the body.
- 33 -