Transportation, Storage And Disposal - Husqvarna LE 322R Operator's Manual

Keypad
Error LED flashes
Error LED stays on
High temperature in-
dicator
The product stops
Introduction
WARNING:
start during transport, remove the
battery and wait a minimum of 5
seconds.
1840 - 004 - 18.10.2022
Possible faults
The handle is not fully expanded
and locked in the operation posi-
tion.
Low battery power.
There is overload in the motor.
Battery error or no signal from
the battery.
Servicing or repair of the product
is necessary.
The motor control is too hot.
The battery is weak.
The battery connector failure.

Transportation, storage and disposal

To prevent accidental
Possible action
Fully extend the handle and lock it in the op-
eration position. Refer to
in operation position on page 13 . After this
step, push the ON/OFF button to make the
error LED go out.
Charge the battery. Refer to
battery on page 13 . After this step, push the
ON/OFF button to make the error LED go
out.
Increase the cutting height. Refer to
the cutting height on page 13 . After this
step, push the ON/OFF button to make the
error LED go out.
Remove grass blockage around the blade.
Remove the battery and manually remove
the grass.
Put the battery in the product correctly. Re-
To start the product on page 15 . After
fer to
this step, push the ON/OFF button to make
the error LED go out.
Replace the battery. Refer to
product on page 15 . After this step, push
the ON/OFF button to make the error LED
go out.
Stop the product immediately and speak to
your Husqvarna service agent.
Stop the motor and wait until it has become
cool.
Charge the battery. Refer to
battery on page 13 .
Examine the battery connector.
To set the product in transport position
1. Remove the grass catcher (if installed).
To set the product
To charge the
To set
To start the
To charge the
23