Husqvarna LE 322R Operator's Manual page 13

3. Connect the power cord to the battery charger
and a mains socket.
To charge the battery
CAUTION:
battery, the battery charger and the
terminals on the battery are clean and
dry. Do not put the battery in the
battery charger if it is dirty or wet.
1. Connect the battery charger to a power outlet.
The charging LED flashes red 1 time and
green 1 time.
CAUTION:
battery charger to a power outlet
with the voltage and frequency
specified on the rating plate.
2. Connect the battery to the battery charger.
The charging LED comes on.
3. Remove the battery from the battery charger
when it is fully charged. Push the battery
indicator button for battery status. When all
the LED indicators come on, the battery is
fully charged.
4. Pull the power plug to disconnect the battery
charger from the power outlet. Do not pull the
power cord.
Battery charging status
A Husqvarna Li-ion battery can be charged
or used at all charging levels. The battery is
not damaged. A fully charged battery will not
decrease its charge when the battery is left in the
charger.
LED display
LED 1 flashes
LED 1 is lit, LED 2
flashes
LED 1, LED 2 are lit,
LED 3 flashes
LED 1, LED 2, LED 3
are lit, LED 4 flashes
LED 1, LED 2, LED 3,
LED 4 are lit
1840 - 004 - 18.10.2022
Make sure that the
Only connect the
Charging status
0%-25%
25%-50%
50%-75%
75%-100%
Fully charged
To set the product in operation position
1. Push and hold the release button.
2. Lift the handle to upright position until the
latches go into the one of the slots on the
handle support.
Note:
Before use, please make sure that the
latch is in the slot of the support plate.
3. Release the handle release button.
To set the cutting height
The cutting height can be adjusted in 7 levels.
13