Husqvarna LE 322R Operator's Manual page 19

Maintenance schedule
The maintenance intervals are calculated from
daily use of the product. The intervals change if
the product is not used daily.
Do a general inspection.
Clean the product.
Clean or replace the filter
Make sure that the safety devices on the product are not defective. *
Examine the cutting equipment.
Examine the cutting cover *
Do a check of the motor brake handle *
Make sure that the ON/OFF button operates correctly and is not defec-
tive.
Examine the battery for damage.
Do a check of the battery charge.
Make sure that the release buttons on the battery operate correctly
and that the battery locks into the product.
Examine the battery charger for damage and make sure that it oper-
ates correctly.
Examine the connections between the battery and the product. Also
examine the connection between the battery and the battery charger.
To do a general inspection
• Make sure that the nuts and screws on the
product are tightened.
• Make sure that the cables on the product are
not in a position where they can get damaged.
To clean the product
• Clean plastic parts with a clean and dry cloth.
• Do not use water to clean the product. Water
can enter the battery or the motor and cause
short circuit or damage to the product.
• Do not use a high pressure washer to clean
the product.
• Do not flush water directly on the motor.
• Use a brush to remove leaves, grass and dirt.
1840 - 004 - 18.10.2022
For maintenance identified with * refer to
Safety on page 6 .
instructions in
To clean the battery and the battery
charger
WARNING:
or the battery charger with water.
• Make sure that the battery and the battery
charger are clean and dry before you put the
battery into the battery charger.
• Clean the battery terminals with compressed
air or use a soft and dry cloth.
• Clean the surfaces of the battery and the
battery charger with a soft and dry cloth.
Each
Monthly
use season
X
X
X
X
X
X
X
X
X
X
X
X
Do not clean the battery
Each
X
19