Do you have a question about the LTH130 and is the answer not in the manual?
Questions and answers
Larry Renner
May 14, 2025
The switch will not engage the blades
1 comments:
Mr. Anderson
May 21, 2025
The switch may not engage the blades on the Husqvarna LTH130 due to several possible reasons:
1. Blown fuse – check and replace if necessary. 2. Faulty ignition or light switch – inspect and replace if needed. 3. Loose or damaged wiring – check all connections. 4. Worn or damaged mower drive belt – inspect and replace. 5. Improper blade installation – verify correct installation. 6. Clogged mower deck or vent holes – clean underside and around mandrels. 7. Poor cable or plug connections – clean and secure them.
Check these components systematically to identify the cause.
Need help?
Do you have a question about the LTH130 and is the answer not in the manual?
Questions and answers
The switch will not engage the blades
The switch may not engage the blades on the Husqvarna LTH130 due to several possible reasons:
1. Blown fuse – check and replace if necessary.
2. Faulty ignition or light switch – inspect and replace if needed.
3. Loose or damaged wiring – check all connections.
4. Worn or damaged mower drive belt – inspect and replace.
5. Improper blade installation – verify correct installation.
6. Clogged mower deck or vent holes – clean underside and around mandrels.
7. Poor cable or plug connections – clean and secure them.
Check these components systematically to identify the cause.
This answer is automatically generated