VTech SIP Next Gen Series User Manual page 15

Installing or replacing a cordless
handset battery
To install or replace the handset battery, follow
the steps below.
1. Hold the handset.
2. Press both thumbs down on the edge of the
battery cover near the speaker, and slide the
battery cover downwards.
3. Lift the battery cover off the handset.
4. If you are replacing the battery: Place your
thumb in the slot below the battery, and
lift the battery out of the handset battery
compartment.
5. Place the top of the battery in the handset
battery compartment so that the battery
connectors are aligned.
6. Push the bottom of the battery down into the
battery compartment.
7. Align all the tabs on the handset cover
against the corresponding grooves on the
handset, then slide the handset cover closed.
CAUTIONS
• There may be a risk of explosion if a
wrong type of handset battery is used.
Use only
battery or replacement battery (Model No.
523450AR1000). To order a replacement, call
1-888-907-2007.
• Dispose of used batteries according to the
information in The RBRC® seal.
Installation notes
CAUTION! Please be careful of sharp edges
of base stand that can cause harm during the
installation process.
Avoid placing the phone too close to:
• Communication devices such as television
sets, DVD players, or other cordless
telephones
• Excessive heat sources
• Noise sources such as a window with
traffic outside, motors, microwave ovens,
refrigerators, or fluorescent lighting
• Excessive dust sources such as a workshop
or garage
• Excessive moisture
• Extremely low temperature
• Mechanical vibration or shock such as on
top of a washing machine or work bench
EN - 15
the supplied rechargeable