PB Heat 211A Series User's Information Manual

PB Heat 211A Series User's Information Manual

Table of Contents

Advertisement

Available languages

Available languages

Quick Links

U
S
ERIES
TO THE INSTALLER: This manual is the property of the owner and must be affixed near the boiler
TO THE OWNER: This boiler should be inspected annually by a Qualified Service Agency.
WARNING
If the information in this manual is not
followed exactly, a fire or explosion
may result causing property damage,
personal injury or loss of life.
– Do not store or use gasoline or other
flammable vapors and liquids in the
vicinity of this or any other appliance.
– WHAT TO DO IF YOU SMELL GAS
• Do not try to light any appliance.
• Do not touch any electrical switch;
do not use any phone in your
building.
• Immediately call your gas supplier
from a neighbor's phone. Follow the
gas supplier's instructions.
• If you cannot reach your gas supplier,
call the fire department.
– Installation and service must be
performed by a qualified installer,
service agency or the gas supplier.
Service Agency
Address
Boiler Model No.
I
SER'S
NFORMATION
211A
for future reference.
TO BE COMPLETED BY THE INSTALLER
Serial No.
PB HEAT, LLC
131 S. CHURCH ST • BALLY, PA 19503
M
ANUAL
G
B
AS
MISE EN GARDE
Négliger de suivre ces instructions à la
lettre pourrait provoquer un incendie ou une
explosion causant des dégâts matériels, des
blessures ou la mort.
– Ne pas ranger ou utiliser de la gazoline ou
d'autres liquides ou gaz inflammables à
proximité de cet appareil ou d'un autre du
même type.
– QUE FAIRE SI VOUS DÉTECTEZ UNE
ODEUR DE GAZ
• Ne pas tenter d'allumer l'appareil.
• Ne toucher à aucun interrupteur
électrique ; n'utiliser aucun appareil
téléphonique dans l'immeuble.
• Contacter immédiatement votre fournisseur
de gaz à partir du téléphone d'un voisin.
Suivre les instructions données par votre
fournisseur de gaz.
• S'il est impossible de rejoindre le
fournisseur de gaz, appeler le service
des incendies.
– L'installation et l'entretien doivent être
effectués par un installateur qualifié, une
société d'entretien ou le fournisseur de gaz.
OILERS
Phone No.
Date of Installation:
GG8045 R10 (04/20-2C)
Printed in U.S.A.
©2020 PB Heat, LLC. All rights reserved.

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the 211A Series and is the answer not in the manual?

Questions and answers

Summary of Contents for PB Heat 211A Series

  • Page 1 TO BE COMPLETED BY THE INSTALLER Service Agency Phone No. Address Boiler Model No. Serial No. Date of Installation: PB HEAT, LLC 131 S. CHURCH ST • BALLY, PA 19503 GG8045 R10 (04/20-2C) Printed in U.S.A. ©2020 PB Heat, LLC. All rights reserved.
  • Page 2 INSTRUCTIONS FOR OPERATION 1. The installation is not complete until Rating and Lighting Plates are on the boiler and the “User’s Information Manual” and “Installation Instructions” are hung near the boiler. 2. System should be maintained in good repair. Radiators, baseboard units and/or convectors must be kept clean.
  • Page 3 Figure 1: Lighting Instructions, Standing Pilot...
  • Page 4 POUR VOTRE SÉCURITÉ, LISEZ AVANT L’ALLUMAGE MISE EN GARDE: Négliger de suivre ces instructions à la lettre pourrait provoquer un incendie ou une explosion causant des dégâts matériels, des blessures ou la mort.  A. Cet appareil est muni d’une ou plusieurs veilleuse(s) Contacter immédiatement votre fournisseur de gaz permanente(s) qui doivent être allumées à...
  • Page 5 Figure 2: Operating Instructions, Spark Ignited Pilot...
  • Page 6 POUR VOTRE SÉCURITÉ, LISEZ AVANT L’ALLUMAGE MISE EN GARDE: Négliger de suivre ces instructions à la lettre pourrait provoquer un incendie ou une explosion causant des dégâts matériels, des blessures ou la mort.  S’il est impossible de rejoindre le fournisseur A.
  • Page 7 ANNUAL INSPECTION PROCEDURE A. Flue product carrying areas of the boiler and the vent system should be thoroughly inspected each year by an experienced, qualified service agency using the following procedure. 1. The unit must be “shut down” and allowed to cool. 2.
  • Page 8 ANNUAL INSPECTION PROCEDURE (Continued) C. Check for water leaks at boiler and system piping and for steam leaks at air vents. Frequent fresh makeup water will reduce boiler life. Automatic water feeders can mask the issue of frequent fresh makeup water. A qualified service agency must verify system integrity during periodic maintenance. D.

Table of Contents