Electrolux N7E Installation And Operating Manual page 19

E E . . 1 1 1 1 . . 1 1 A A u u t t o o m m a a t t i i c c f f i i l l l l i i n n g g p p a a n n s s
H /S1
P / S3
Cold
For correct installation, water inlet pipe for automatic refill "H"
(fig) must be supplied with deionized water or, in alternative,
osmotized water.
Before connecting, allow a certain amount of water to flow in
order to clear the pipe of any waste matter.
E E . . 1 1 2 2 S S a a f f e e t t y y t t h h e e r r m m o o s s t t a a t t
Some of our appliance models use a safety thermostat. This
device cuts in automatically when temperatures exceed a set
value, shutting off the gas supply (gas appliances) or the
electricity (electric appliances).
I I M M P P O O R R T T A A N N T T
Resetting of the safety thermostat must be carried
out by specialised personnel; contact the Service
Centre.
Tampering with the safety thermostat invalidates
the warranty.
E E . . 1 1 2 2 . . 1 1 I I n n t t e e r r v v e e n n t t i i o o n n
If the limiter in the pots trips and the indicator "L" on the
control panel illuminates, it could be the case of an incorrect
use. Verify if:
• the appliance is used empty,
• the cavity has a low water level,
• a malfunction occurs.
NOTE!
If the limiter trips anyway, contact a specialised
technician.
F F I I N N S S T T R R U U C C T T I I O O N N F F O O R R T T H H E E U U S S E E R R
F F . . 1 1 G G e e n n e e r r a a l l p p r r e e c c a a u u t t i i o o n n s s
• The appliance is intended for industrial use by trained
personnel.
• This appliance must only be used for its expressly designed
purpose; i. e. for cooking or preparing foods in a watery
medium. Any other use is deemed improper.
• Never use coarse kitchen salt as this, slowly dissolving,
could cause corrosion of the bottom of the tank.
Therefore it is advisable to use fine salt (grains smaller
than 3 mm) adding it to the water only when boiling.
If the salt available is coarse, dissolve it first in warm water
in a separate container.
P / S2
Hot
E E . . 1 1 2 2 . . 2 2 R R e e s s e e t t
When the equipment cools down the limiter is reset automati-
cally (only on indirect pots).
I I M M P P O O R R T T A A N N T T
Tampering with the safety limiter invalidates the
warranty.
E E . . 1 1 2 2 . . 3 3 D D e e v v i i c c e e s s f f o o r r p p r r e e s s s s u u r r e e c c o o n n t t r r o o l l
Indirect version:
• Air discharge valve "D" regulates the pressure inside the
cavity, guaranteeing the release of air during heating.
It also allows air into the cavity during cooling when the
pressure tends to fall below the atmospheric value.
• When the pressure value approaches 0.5 bar, safety valve
"S" cuts-in releasing steam from the cavity to the outside.
S
D
W W A A R R N N I I N N G G
Operating the appliance without
water in the cavity causes seri-
ous damage due to overheating
of the s/steel container and the
internal parts.
L
19