Initialization And Adjustment; Opening The Installation Menus - Furuno FR-1500 MARK-3 Series Installation Manual

INITIALIZATION AND ADJUSTMENT

5.1 Opening the Installation Menus

The display unit RDP119 can be used as a sub display. If the sub display is
installed, set heading alignment, sweep timing, video signal level, antenna height
and STC slope for each display unit. Most adjustments are done on the INSTAL-
LATION SETUP menu. This menu is normally locked to prevent adjustment. Open
the menu as follows:
1. Turn off the power.
2. Turn on the power while pressing and holding down the GAIN control.
3. Press the [MENU] key to display the main menu.
4. Press the [0] key four times.
5. Press the [5] key twice to select INSTALL.
6. Press numeric keys to select item and set option.
The complete installation menus appear below.
[MENU], [0] four times, [5] twice
SET UP 1
1. ↑
2. HDG ADJ
3. TIMING
4. VIDEO LEVEL
5. MBS-T
6. MBS-L
7. ANT H
8. STC SLOPE
9. ALM LEVEL
0. ↓
OTHER
1. ↑
2. ECHO AVG
3. TX/ANT
4. ON TIME
5. TX TIME
6. RNG UNIT*
* R-type radar only.
Default settings are
cir/cumscribed.
[0] key
0.0°
0.044NM
AUTO MAN
000
000
5m 7.5m 10m
15m 20m 30m
SLOW MID FAS
LOW MID HIGH
[0] key
OFF ON
ROTATE STOP
000000.0H
000000.0H
NM KM SM
[8] key
Figure 5-3 Installation menus
SET UP 2
1. ↑
2. LOG RATE 0200
3. HDG SNSR GYRO MAG OFF
4. KEY BEEP OFF ON
5. HU TB OFF ON
6. VIDEO NORMAL QV
7. OS & ANT
8. BLIND SCTR
9. TUNE SET
0. ↓
[7] key
OS & ANT
1. ↑
2. LENGTH 000m
3. WIDTH 00m
4. FORE (RDR) 000m
5. PORT (RDR) 000m
6. FORE (GPS) 000m
7. PORT (GPS) 00m
BLIND SECTOR
1. ↑
2. FROM 180° SECTOR 000°
3. FROM 180° SECTOR 000°
5-1