Delivering The Setup Data; Restarting The Slave Idt - FujiFilm ID-T741 Service Manual

INSTALLATION 3. Setup

3.5 Delivering the Setup Data

Perform the following procedure to deliver the network information
from the master IDT to slave IDT units.
(1) Start the maintenance mode at the master IDT unit.
The maintenance mode starts.
(2) When the "Maintenance process" menu screen opens, select
[Network setup].
The "Network setup" screen opens.
(3) Touch [DELIVERY].
The delivery execution confirmation screen opens.
009-052-02
2.20.99 FM2434 (ITC)
(4) Touch [Yes].
The network information is then delivered to the slave IDT
units. When delivery is completed, the "Process completion"
confirmation screen opens.
(5) Touch [OK].
The system returns you to the "Network setup" screen.

3.6 Restarting the Slave IDT

Restart all the slave IDT units by turning the sub-switch OFF and
then back ON.
The maintenance mode starts.
FT100234.EPS
FT100283.EPS
Installation-34
FCR ID-T741 Service Manual