Fujitsu ASUH09LPAS Service Manual page 141

Function
Mode
setting
11 60-11
NOTE: Input of Operation/Stop depends on the setting of function setting 46.
00: Operation/Stop mode 1 (R.C. enabled)
01: (Setting prohibited)
02: Forced stop
03: Operation/Stop mode 2 (R.C. disabled)
¢ Input signal type
External Input and Output PCB:
The input signal type can be selected.
Signal type (edge or pulse) can be switched by the DIP switch SW302 on the External Input and
Output PCB.
2-3. Combination of external input and output
Indoor unit
Rotary
SW
CN47
External heater
D
output
Edge
- (05-17) -
External output
External Input and Output PCB
1
CN310 CN311
Indoor unit fan
Operation/Stop
operation status
The width of pulse must be
longer than 200 msec.
Pulse
2 3
CN312
Error status
2. External input and output