Advertisement
W O L F
OV E N D O O R
Failure to insert the hinge pin in the
appropriate hinge arm will cause damage
to the range. Minor injuries may occur.
IMPORTANT NOTE: The oven door(s) should
not be removed unless it is necessary to fit the
range through a tight doorway. Door removal
should only be done by a qualified service
technician or installer. Door removal and rein-
stallation may cause damage to the porcelain
interior of the oven or door(s).
If removal of the oven door(s) is necessary, a
hinge pin, supplied with the range, will need to
be inserted in the appropriate hinge arm. For
each oven door, only one hinge arm is spring
loaded, requiring use of the hinge pin for
removal of the oven door. The hinge pin will
be found taped to the inside of the oven door.
For 30" (762) and 36" (914) gas ranges, the
hinge pin will be inserted through the hole in
the right hinge arm (facing the unit). On 48"
(1219) and 60" (1524) gas ranges, the spring
hinges are located on the outer edges of the
unit. On these units, the left oven door will
have the spring hinge on the left side and the
right oven door will have the spring hinge on
the right side. Refer to the illustrations below
for the location of the spring hinge(s) for your
specific model.
Place Hinge Pin on
Spring Hinge Side of Door
Spring hinge location for 30" (762)
and 36" (914) gas ranges
12
G A S R A N G E S
R E M O V A L
Place Hinge Pins on
Spring Hinge Side of Door
Spring hinge locations for 48" (1219)
and 60" (1524) gas ranges
If removal of the oven door(s) is necessary,
follow these steps:
1)
Open the oven door to its fully opened
position and insert the supplied door hinge
pin through the hole in the appropriate
hinge arm. Refer to the illustration below.
2)
Remove both upper and lower hinge
retainer mounting screws. NOTE: The oven
gasket may have to be moved slightly to
access the bottom screws.
3)
After removing the mounting screws, move
the hinge retainer plate forward slightly.
NOTE: The hinge retainer plate will remain
on the door hinge assembly after the
mounting screws have been removed.
4)
Carefully close the oven door to about a
60° angle from horizontal and lift the door
away from the oven. NOTE: A slight racking
motion may be required for removal.
5)
For 48" (1219) and 60" (1524) gas ranges,
complete these steps for both oven doors.
Do not lift or carry the oven door by the
door handle.
Hinge
Retainer
Plate
Hinge
Pin
Kickplate
Oven door removal
Upper Mounting
Screw
Advertisement
