3
Installation and Configuration
Removing the fan module
Step 1.
Loosen the retainer screws on the fan modules which are going to be
replaced and removed.
Step 2.
Hold the fan module's handle (silver), and slowly pull out fan module
while supporting it.
Mounting the fan module
Step 1.
Slowly insert the fan module into the fan module slot.
Step 2.
Tighten the retainer screws.
Step 3.
Make sure that the status LED is NOT blinking in orange, and the STACK
ID LED is NOT displaying any of the followings.
"11": Fan 1 failure
"12": Fan 2 failure
"13": Fan 1 and Fan 2 failures
Replacing the fan module
After removing the fan module, then mount the fan module.
Fan module slot
18
Fan module (Fan 1)
Fan module (Fan 2)
Handle (silver)
Retainer screws