Table of Contents
Advertisement
3
Installation and Configuration
Removing the power module
Step 1.
Unplug the power cord from the power module which is going to be
replaced and removed, and shut off the power.
Step 2.
Make sure that the power status LED of the power module and the
POWER1 LED, the POWER2 LED or both LEDs of the Ethernet switch itself
are turned off.
Step 3.
Push the power module's release lever (black) in to the left side, and
release the retainer.
Step 4.
Hold the power module's handle (black), and slowly pull out the power
module while supporting it.
Mounting the power module
Step 1.
Remove the blank panel on the power module slot. Carefully store the
removed blank panel.
Step 2.
Insert the power module into the power module slot until a "clunk" is
heard.
Step 3.
Attach the power cord on to the power module.
Step 4.
Make sure that the power status LED of the power module and the
POWER1 LED, the POWER2 LED or both LEDs of the Ethernet switch itself
are turned off.
Replacing the power module
After removing the power module, then mount the power module.
Power module slot
Power status LED
16
Handle (black)
Blank panel
Power module 1
Release
Release lever (black)
Advertisement
Table of Contents
