Table of Contents
Advertisement
only when your home photovoltaic
system can provide sufficient energy
or the energy tariff is good.
Requirements
¡ The smart energy system (energy
manager) must use the EEBus Initi-
ative communications standard.
¡ You have read about how to con-
nect your appliance to the smart
energy system (energy manager)
in the instruction manual for the
smart energy system (energy man-
ager).
Press and hold
1.
seconds.
a The display shows Aut.
Set the programme to position 7.
2.
a The display shows EnG.
Press inicio/pausa+carga.
3.
a The appliance is connected to the
smart energy system (energy man-
ager).
a If the appliance has connected to
the energy manager successfully,
the display shows and .
Activate Flex Start if you want the
4.
smart energy system (energy man-
ager) to start up your appliance.
→ "Activate Flex Start", Page 45
Activate Flex Start
Activate Flex Start to allow your smart
energy system (energy manager) to
start your appliance once your home
photovoltaic system is able to
provide sufficient energy or the en-
ergy tariff is good.
Requirement: The smart energy sys-
tem (energy manager) cannot start
your appliance until it is connected to
the appliance.
Set the programme you require.
1.
Press - termin. + to set the re-
2.
quired time.
Press inicio/pausa+carga.
3.
for approx. 3
Press inicio/pausa+carga.
4.
a The display shows
is activated. The appliance waits to
be started by the smart energy
system (energy manager).
a If the time changes on the display,
e.g. to 8 h, the smart energy sys-
tem (energy manager) has estab-
lished a time at which your appli-
ance can start.
a If the smart energy system (energy
manager) does not start the appli-
ance within the set time, the appli-
ance will start the programme itself
before the set time period ends.
The programme ends when the
time period ends.
Note
Flex Start is deactivated for safety
reasons in the following circumstances:
¡ Press inicio/pausa+carga.
¡ Open the door.
¡ Switch off the appliance.
¡ Power failure.
Activating Wi-Fi on the appli-
ance
Note: When Wi-Fi is activated, the en-
ergy consumption increases in com-
parison to the values specified in the
consumption value table.
Press and hold
1.
seconds.
Set the programme to position 4.
2.
a The display shows Con.
Press inicio/pausa+carga re-
3.
peatedly until the display shows
On.
a Wi-Fi is activated.
Note: If Wi-Fi is activated, the appli-
ance will not switch itself off automat-
ically.
Home Connect en
and Flex Start
for approx. 3
45
Advertisement
Table of Contents
