Marantz RC2000MKII User Manual page 17

To "clone" (duplicate) ALL of the memory
contents of one RC2000 Mk w w into another
RC2000 Mk w w , please follow these steps:
Place the source RC2000 Mk w (the one with all of the
1.
customized commands, names, macros, macro
sequences, and the like) with its infrared transmitter
window @3 facing the infrared sensor @4 of another
"fresh" RC2000 Mk w (5 cm, or 2 inches apart).
Transmitting RC2000 Mk w w
Approx. 5 cm (2 inches)
Press the CLONE button e of the
2.
source RC2000 Mk w with a paper
clip tip, and select "CLONE TX" (clone
transmit) mode (see Figure 17).
POWER
SOURCE
ON
ON/OFF
CLONE MACRO
Press the CLONE button.
3. Press the CLONE button e of the
learning (receiving) RC2000 Mk w
with the tip of a paper clip or a
similar object, and select "CLONE
RX" (clone receive mode). Then
press the PLAY button !5 .
POWER
SOURCE
ON
ON/OFF
CLONE MACRO
Press the CLONE button.
Press the source RC2000 Mk w's transport control
4.
PLAY !5 key to begin the infrared data transmission
sequence. Now the "LEARN" indicator of receiving
RC2000 Mk w starts to blink.
TUNER
CH
Press the PLAY button.
Receiving RC2000 Mk w w
OFF
MODE
Figure 17
OFF
MODE
Figure 18
CD TAPE AUX AMP
VOL
33
During the transmission, the LCD windows of both
RC2000 Mk w remote controls will show a bar-type
indicator, moving from left to right during the
transmission process.
After all bars are lit up on both displays, "TX OK"
(transmission OK) will appear in the source RC2000
Mk w's LCD window, and "RX OK" (reception OK) will
appear in the "cloned" RC2000 Mk w's LCD window,
confirming the end of the copying process (see
Figures 19 and 20).
Figure 19
If the audible beep indicator is on, it will sound to let
you know that cloning is complete.
¼ Please be sure that, during the copying process,
neither RC2000 Mk w is physically disturbed (ideally,
they should be placed on a table or other surface,
and not hand-held during the copying process). If,
for some reason, the copying process was
interrupted, the "clone" RC2000 Mk w's LCD display
window will indicate "RX NG" (reception no good).
Simply begin the clone process anew by repeating
the above steps.
If the source RC2000 Mk w's memory contents are at
5.
or near full capacity, the copying process will take
about 3 minutes. After completion of the copying
(cloning) process, press the CLONE button on both
RC2000 Mk w's with the paper clip tip, and select the
OFF mode.
Then, you'll have two identically programmed RC2000
Mk w remotes, one of which can again be used as your
system's primary remote control, and you'll have the
added confidence of knowing that in the event of
inadvertent programming (or memory contents being
cleared somehow), you can simply retrieve the
"backup" RC2000 Mk w that you've safely tucked
away, and within minutes restore the programming
contents of the original RC2000 Mk w with your
customized configuration.
ON
LEARNING REMOTE CONTROL
Press on both the receiving and transmitting units.
LEARN
Figure 20
POWER
SOURCE
OFF
ON/OFF
CLONE MACRO MODE
34