Installing For Dos - IBM ThinkPad 755CX Manual

Installing the Mwave Support Software
194
IBM ThinkPad 755CX User's Guide

Installing for DOS

DOS
To install the Mwave support software for DOS, do the following:
1
Turn on the computer.
2
Insert the Mwave DSP Features Diskette 1 for DOS into
the diskette drive.
3
At the command prompt, type A:INSTALL; then press
Enter.
The following screen, which enables you to specify the
directory location of Mwave support software, appears:
4
If this directory is acceptable, press Enter. Otherwise,
type the directory name; then press Enter.
5
Follow the instructions on the screen.
6
After the installation is complete, remove any diskette
from the diskette drive; then restart DOS to activate the
Mwave support software.
You have completed the installation of the Mwave support software
for DOS.
Please specify the directory for the
installation of Mwave products.
Destination Path
c:\MWD
OK Cancel