Preparation; Installing The Hanging Bracket - Hinkley CHET 36 Instruction Manual

PREPARATION

PREPARATION:
Verify you have all parts before beginning
the installation. Check pulp paper insert
closely for missing parts. Remove motor from
packing. To avoid damage to finish, assemble
motor on soft padded surface or use the
original pulp paper insert in motor box.
DO NOT LAY MOTOR HOUSING ON ITS SIDE
AS THIS COULD RESULT IN SHIFTING OF
MOTOR IN DECORATIVE ENCLOSURE.

INSTALLING THE HANGING BRACKET

CAUTION: To avoid possible electrical shock, be sure electricity is
turned off at the main power box before wiring. All wiring must be in
accordance with National and Local Electrical Codes and the ceiling fan
must be grounded as a precaution against possible electric shock.
Locate ceiling joist where fan is to be mounted, being sure location
1
agrees with the requirements in the minimum clearance section
of this guide. Wood joists must be sound and of adequate size to
support 35 pounds (See page 2, items 3 and 4).
If not already present, mount a UL listed outlet box marked
2
"suitable for fan support" following the instructions provided with
the outlet box. The outlet box must be able to support a minimum
of 35 pounds.
Remove canopy from hanger bracket. Remove twist-lock trim
3
ring by rotating counter-clockwise. Remove canopy screw that
does not have key slot in canopy. Loosen screw with key slot and
remove canopy.
Attach hanging bracket to outlet box using screws provided with
4
the outlet box.
Yoke cover
Motor Housing
Blade
LK pan
Parts identification on assembled fan.
Screws
Figure 1
Outlet Box
Hanger
Bracket
Flat Washer
Spring Washer
Outlet Box Screw
Figure 2
©2022 Hinkley Lighting, Inc. hinkley.com
Canopy
Downrod
Shade
Hanger
bracket
Canopy
Trim Ring
5