Installing The Blades; Installing The Light Kit Pan - Hinkley CHET 36 Instruction Manual

INSTALLING THE BLADES

NOTE:
Remove any rubber supports that are
installed for shipping.
Attach a blade to the fan motor assembly by inserting the blade
1
into slots in the side of the fan motor assembly ,and aligning the
three screws holes in the blade with the holes, then secure with
screws .
2
Make sure all the screws are firmly tightened.
Repeat these steps for the remaining blades.
3

INSTALLING THE LIGHT KIT PAN

CAUTION: To reduce the risk of electrical shock, disconnect the
electrical supply circuit to the fan before installing the light kit.
Loosen but do not remove two of three mounting screws from
1
the fan motor assembly; Remove one mounting screw.
Push the light kit pan up to the fan motor assembly so that
2
the two loosened screw heads fit into the keyhole slots. Turn
the light kit pan clockwise, tightened the screws. Re-install the
screw that was removed in step 1 and tighten firmly.
10 hinkley.com
Blades
Screws
Mounting Hub
(bottom of motor)
LK Pan
Screws