Fig 1 Fig 3 Wall Mounting Wiring diagram Flow SW. A - Heating Element B - XG-PC Front PCB C - ELCB D - XG-PC Control PCB E - Thermal Cut-Out 220-240 VAC. ONLY Fig 2 Fig 4 STIEBEL ELTRON...
7. Terminal block for earth wire 16. Filter 8. ELCB 17. Rubber seal 9. Connector to PCB control 18. Water Valve (Base) 19. Power Light 10. Reed switch 20. Connector to PCB Control (Cover) Cover Base Pic 8 Fig 5 STIEBEL ELTRON...
- Release cover securing screw. Fig 6 Fig 8 - Feed the connection cable seal - Open and remove cover. in the rear wall. Fig 7 Fig 9 STIEBEL ELTRON...
Page 7
- Guide the unit over the wall securing screws and slide it downwards. N wire Fig 12 Fig 10 - Fit a secure connection cable (See recommended cable size in ensure dimensions are correct. technical data table) L wire Earth wire Fig 11 Fig 13 STIEBEL ELTRON...
Page 8
- Straighten the unit and tighten the screws. Fig 16 Fig 14 - Connect the electrical supply - Fit the cover and secure with from cover into the PCB control. the screw. Fig 15 Fig 17 STIEBEL ELTRON...
Page 9
- Fit the cold water pipe thoroughly position. (Fig 5 number 18). Fig 20 Fig 18 - Fit the filter and silicone gasket - Fit the shower accessories to (Fig 5 number 16, 17). the unit. Fig 19 Fig 21 STIEBEL ELTRON...
2.1 Description of the unit. This appliance is designed for domestic The STIEBEL ELTRON XG is a slim and use. It can be used safely by untrained pressureless instantaneous water heater persons. The appliance can also be...
2.2 The essentials - in brief a. Water valve b. Rotary control for temperature adjustment c. “Power” light d. Shower accessories Shower head level must not be higher than the unit. Fig 22 STIEBEL ELTRON...
ELCB once a month. 2.3.2. The unit is equipped with a Before using this unit, switch on the Double action thermostat. electrical supply then press the Reset Button (E). Incase of permanent thermostat cut off, contact Stiebel services. Push Fig 23 STIEBEL ELTRON...
4.9 - 21.3 240 V 4.2 - 17.5 5.4 - 22.5 Note: The cable sizes can only be a guiding value. Always abide by the corresponding local standards, laws and regulations. Stiebel Eltron cannot be held liable for any damages. STIEBEL ELTRON...
Stiebel Eltron installer. The device must be capable of - Hand over this instruction manual being isolated from the mains, to the user and to be kept on a safe for example by fuses, with an isolating place for future reference.
- The shower head is - Clean shower head blocked with dirt or or remove limescale. limescale. - ELCB activated. - Press ELCB Reset button. STIEBEL ELTRON...
ก�รติ ด ตั ้ ง บนผนั ง วงจรไฟฟ้ � Flow SW. A - Heating Element B - XG-PC Front PCB C - ELCB D - XG-PC Control PCB E - Thermal Cut-Out 220-240 VAC. ONLY ภ�พที ่ 2 ภ�พที ่ 4 STIEBEL ELTRON...
Page 32
Size:A5 Material: White paper 80 g. Plastic bag : 7 x 11 INCH Product code : XG 35 EC (STE) : 230997 / XG 45 EC (STE) : 230998 Part name : Operating instruction XG_EC Rev.02 Part no. 7901-292761...
Need help?
Do you have a question about the XG 35 EC and is the answer not in the manual?
Questions and answers