Gx Device Connection - Victron energy BMV-700 Manual

3. Connect the new shunt to the electrical system and battery monitor head unit as shown in chapter
connections [7]. Pay special attention to the orientation of the shunt circuit board in relation to the battery and load
connections.
4. Follow the setup wizard; see the
5. After completing the setup wizard, set the proper shunt current and shunt voltage according to the
Shunt voltage [32] settings.
6. If the battery monitor reads a non-zero current, even when there is no load, and the battery is not being charged, calibrate the
zero current reading using the

3.8. GX device connection

If the system contains a GX device such as a
VE.Direct cable or a VE.Direct to USB
Once connected, the GX device can be used to read out all monitored battery parameters. For more information see chapter
Connecting to a GX device and the VRM portal
The battery monitor is connected to a
Page 9
Manual - BMV-700
Setup wizard [10] chapter.
Zero current calibration [26] setting.
Cerbo GX, the battery monitor can be connected to the GX device using a
interface.
[21].
Loads
&
Chargers
Battery bank
Cerbo GX
Basic electrical
Shunt current [32]
and a GX Touch screen.
and the
Installation