Operation - Makita AT1150A Instruction Manual

2. Insert strip of staples into the magazine. Two strips
of staples can be loaded.
3. Depress the lock pin lightly and pull the pusher to
unhook it.
With the lock pin depressed, return the pusher
slowly and gently to the original position.
Keep depressing the pusher until it passes through.
1
Connecting air hose
Slip the air socket of the air hose onto the air fitting on the
stapler. Be sure that the air socket locks firmly into posi-
tion when installed onto the air fitting. A hose coupling
must be installed on or near the tool in such a way that
the pressure reservoir will discharge at the time the air
supply coupling is disconnected.
007212
007213
1. Pusher
007197
1. Air fitting
1
2. Air socket
2

OPERATION

CAUTION:
• Make sure all safety systems are in working order
before operation.
1. Pull the trigger first and then place the contact ele-
ment against the workpiece.
1
2
1
2
3
2. To drive a staple, you may place the contact ele-
ment against the workpiece and pull the trigger, or
No. 1 method is for continuous stapling.
No. 2 method is for intermittent stapling, when you wish
to drive a staple carefully and very accurately.
CAUTION:
• However when the tool is set to the "Intermittent
Staplling" mode, WITH THE TRIGGER HELD IN A
HALF-PULLED POSITION, an unexpected stapling
could occur, if contact element is allowed to re-con-
tact against the workpiece or the other surface
under the influence of recoil.
In order to avoid this unexpected stapling, perform
as follows;
A. Do not place the contact element against the work-
piece with excessive force.
B. Pull the trigger fully and hold it on for 1-2 seconds after
stapling.
For No. 2 method, the OPTIONAL SEQUENTIAL TRIP
TRIGGER (SINGLE SHOT PART) is used . Replace the
trigger part with this.
6
007199
1. Trigger
2. Contact element
3. Workpiece
3
007198
1. Trigger
2. Contact element
3. Workpiece