Functional Description - Makita AT1150A Instruction Manual

When an air set is not used, oil the tool with pneumatic
tool oil by placing 2 (two) or 3 (three) drops into the air fit-
ting. This should be done before and after use. For
proper lubrication, the tool must be fired a couple of
times after pneumatic tool oil is introduced.

FUNCTIONAL DESCRIPTION

CAUTION:
• Always disconnect the hose before adjusting or
checking function on the tool.
Adjusting depth of stapling
1
To adjust the depth of stapling, loosen the bolt by using
the hex wrench provided with the tool and then slide the
depth adjusting plate up or down.
If staples cannot be driven deep enough, slide the adjust-
ing plate in the direction of arrow as shown in the figure.
If the staples are driven too deep, slide the adjustinhg
plate in the direction of arrow as shown in the figure.
The depth can be adjusted 5 mm to the maximum.
Tighten the bolt securely at the right position after adjust-
ing.
007200
1. Depth adjusting
plate
2. Hex wrench
2
007202
007201
ASSEMBLY
CAUTION:
• Always disconnect the hose before carrying out any
work on the tool.
Hook
CAUTION:
• Always disconnect the hose from the tool.
• Never hook the tool at high location or on potentially
unstable surface.
The hook is convenient for hanging the tool temporarily.
Secure the hook on the tool with the provided screw
using either of two holes in the hook as shown in the fig-
ure.
Loading stapler
CAUTION:
• Always disconnect the hose before loading the tool.
• Do not use deformed staples or staple strip. Failure
to do so causes poor staple feeding.
• Always use staples specified in this instruction
manual. Failure to do so causes poor staple feed-
ing.
• Always return the pusher slowly and gently while
holding it with a hand.
Select staples suitable for your work. Make sure that the
hose is disconnected from the tool.
1. Pull the pusher to the rear of magazine and hook
the groove in the pusher on the lock pin.
5
007315
1. Hook
1
2. Screw
2
007211
1. Lock pin
2. Pusher
1
2