Table of Contents
Advertisement
Available languages
Available languages
<
<
N
N
O
O
T
T
E
E
>
>
Check that the "Rest Time" function is not enabled before entering Test mode.
Learning procedure
The detector must be learnt by the control unit to transmit the signal if motion is detected. Proceed as follows to perform the
device learning procedure.
The detector may be learnt by the control unit only within three minutes from switch-on.
1.
Remove the battery compartment lid and insert the two AA batteries (included).
2.
Make sure that the tamper switch is open (released).
3.
Make sure that the learn function has been activated on the control unit. Within three minutes from switch-on, hold
the function button pressed for 3 seconds and then release it when the blue LED and the illuminator blink once. The
Blue LED will light on for 25 seconds in learning mode, add PIR Camera into the Control Panel during this period
(refer to your Control Panel to finish learn in process). If the PIR is successfully added into the Control Panel, the
Blue LED will flash 6 times to indicate. If PIR is not added within 25 seconds, please repeat learning process.
4.
After having been leant by the control unit, the detector is automatically recorded in the system. Check the control
unit to check that the learning and registration procedure were performed correctly.
Installation
Surface installation:
1. Loosen the fixing screw and gently lift the cover, taking care not to lose the rubber button
over the tamper switch.
2. Perforate the hole arrangements on the base for fixing on a surface.
3. Using the two holes as template, drill the holes corresponding to the surface.
4. Insert the anchor bolts if the device is fixed to plaster or bricks.
5. Screw the base into the anchor bolts.
6. Reposition the cover onto the base.
Corner installation:
1. Perforate the two arrangements for holes on the corner bracket.
2. Using the two holes as template, drill the holes corresponding to the surface.
3. Insert the anchor bolts if the device is fixed to plaster or bricks.
4. Screw the bracket into the anchor bolts.
5. Fasten the detector to the bracket.
Technical Specifications
Radio frequency band: 868,600-868.700MHz
Maximum radio power transmitted: 9,69dBm
Hereby, URMET S.p.A. declares that the radio equipment type: INDOOR INFRARED DETECTOR WITH CAMERA IR600FC/RF
is in compliance with Directive 2014/53/EU. The full text of the EU declaration of conformity is available at the following internet
address: www.elkron.com.
CLICK ON THE FOLLOWING LINK OF THE ELKRON SITE TO ACCESS THE PRODUCT TECHNICAL SHEET AND
DOWNLOAD THE COMPLETE MANUAL:
DIRECTIVE 2012/19/EU OF THE EUROPEAN PARLIAMENT AND OF THE COUNCIL of 4 July 2012 on waste electrical and
electronic equipment (WEEE).
The symbol of the crossed-out wheeled bin on the product or on its packaging indicates that this product must not be
disposed of with your other household waste.
Instead, it is your responsibility to dispose of your waste equipment by handing it over to a designated collection point
for the recycling of waste electrical and electronic equipment. The separate collection and recycling of your waste
equipment at the time of disposal will help to conserve natural resources and ensure that it is recycled in a manner
that protects human health and the environment.
For more information about where you can drop off your waste equipment for recycling, please contact your local city office,
your household waste disposal service or the shop where you purchased the product.
ELKRON
Tel. +39 011.3986711 - Fax +39 011.3986703
www.elkron.com
SIMPLIFIED EU DECLARATION OF CONFORMITY
– mail to: info@elkron.it
Hole provisions
for fixing on
surface (x 2)
Arrangement for holes for
corner fixing (x 2)
ELKRON is a trademark of URMET S.p.A.
Via Bologna 188/C – 10154 Turin (TO) Italy
www.urmet.com
MADE IN TAIWAN
Advertisement
Table of Contents
