Combustion Head Setting; Burner Refitting - Riello RLS 130/EV Installation, Use And Maintenance Instructions

4.10 Combustion head setting

The setting of the combustion head depends exclusively on the
maximum delivery of the burner.
Turn screw 6)(Fig. 20) until the notch shown in diagram (Fig. 19) is
level with the front surface of flange 5)(Fig. 20).
Example: maximum burner delivery = 31 GPH.
If diagram (Fig. 19) is consulted it is clear that for this delivery, the
combustion head must be adjusted using notch 7, as shown in
Fig. 20.
D10851
Burner max. output

4.11 Burner refitting

 Refit the burner to the slide bars 3)(Fig. 21) at approximately
4" from the sleeve 4) - burner positioned as shown in Fig. 11,
page 18 - insert the ignition electrode cables.
 Remove the extension bars 31)(Fig. 5, page 10).
 Slide the burner up to the sleeve so that it is positioned as
shown in Fig. 21;
 refit screws 2)(Fig. 21) on slide bars 3) including the safety
plate 15)(Fig. 11, page 18);
Installation
Fig. 19
 secure the burner to the sleeve by tightening screws 1);
 connect the oil pipes again by screwing on the two connectors
 connect the swivel coupling 7) from the graduate sector.
WARNING
1
2 3
20097707
21 GB
20066614
6)(Fig. 11, page 18).
When fitting the burner on the two slide bars, it is
advisable to gently draw out the high tension cables
until they are slightly stretched.
4 5
6
7
Fig. 20
Fig. 21
20096088