Safety Instructions; Symbols - Bosch Rexroth MM7.10 Instruction Manual

About this documentation | BODAS inertial sensor MM7.10

1.3.1 Safety instructions

This documentation contains safety instructions in chapter 2.6
"Product-specific safety instructions" on page 10 and in chapter 3
"General instructions on property damage and product damage" on page 11,
as well as before a sequence of actions or an instruction for action involving a risk
of personal injury and property damage. Always follow the measures for danger
prevention associated with the use of this product.
Safety instructions are set out as follows:
Type and source of danger!
Consequences of non-compliance
▶ Danger prevention measures
• Warning sign: draws attention to the danger
• Signal word: identifies the degree of the danger
• Type and source of danger: indicates the type and source of the danger
• Consequences: describes the consequences of non-compliance
• Precautions: states how the danger can be avoided
Table 2: Hazard classes as defined in ANSI Z535.6
Warning sign, signal word
DANGER
WARNING
CAUTION
NOTICE

1.3.2 Symbols

The following symbols indicate notices that are not safety-relevant but increase
understanding of the documentation.
Table 3: Meaning of symbols
Symbol Meaning
If this information is disregarded, the product cannot be used and/or
operated to its full extent.
▶
Single, independent action
1.
Numbered instruction:
The numbers indicate that the actions must be completed in order.
2.
3.
SIGNAL WORD
Meaning
Identifies a dangerous situation that will result in death or
serious injury if it is not avoided.
Identifies a dangerous situation that may result in death or
serious injury if it is not avoided.
Identifies a dangerous situation that may result in minor to
moderate injury if it is not avoided.
Property damage: The product or surrounding area may be
damaged.
RE 95178-01-B/2022-06-22, Bosch Rexroth AG
5/24