About This Documentation; Validity Of The Documentation; Required And Supplementary Documentation; Representation Of Information - Bosch Rexroth MM7.10 Instruction Manual

4/24 BODAS inertial sensor MM7.10 | About this documentation
Table 1: Required and supplementary documentation
Title
Offer drawing
Inertial sensor MM7.10
Contains the permissible technical data, connections,
main dimensions and circuit diagrams of standard versions.
Inertial Measurement Unit MM7.10
Technical Customer Documentation
Inertial Measurement Unit MM7.10
Mounting guideline
Bosch Rexroth AG, RE 95178-01-B/2022-06-22

1 About this documentation

1.1 Validity of the documentation

This documentation is valid for the following product:
• BODAS inertial sensor MM7.10
This documentation is intended for machine/system manufacturers,
assemblers and service engineers.
This documentation contains important information on the safe and proper
transport, installation, commissioning, operation, maintenance, disassembly and
simple troubleshooting of the product.
▶ Read this documentation completely, in particular chapter 2 "Safety instructions"
on page 7 and chapter 3 "General instructions on property damage and
product damage" on page 11 before you start working with the product.

1.2 Required and supplementary documentation

▶ Only commission the product if the documentation marked with the
book symbol is available to you and you have understood and observed it.

1.3 Representation of information

Uniform safety instructions, symbols, terms and abbreviations are used throughout
this documentation to ensure safe and proper use of the product. For clarification,
they are explained in the sections below.
Document number Document type
RA90896310 Offer drawing
Please request the
offer drawing from your
contact at Bosch Rexroth.
95178 Data sheet
95178_TCD_MM7.10 Technical information
95178_MG_MM7.10 Technical information