–
Position the connector board and combination instrument
on the upper triple clamp.
–
Mount and tighten screws
Guideline
Remaining screws,
chassis
–
Route the clutch line with the clutch master cylinder
toward the front between the upper and lower triple
402736-10
clamps.
–
Install the fork legs. (
(EXC‑F EU/US, XCF‑W)
–
Remove screws
–
Move the handlebar supports to the desired position and
mount and tighten screws
Guideline
Screw, handle-
bar holder
Info
Position the left and right handlebar supports
evenly.
S01414-10
Warning
Danger of accidents A repaired handlebar poses a
safety risk.
If the handlebar is bent or straightened, the mate-
rial becomes fatigued. The handlebar may break
as a result.
–
E00483-01
–
Position the handlebar.
Info
Make sure the cables and wiring are positioned cor-
rectly.
–
Position the handlebar clamps. Mount and tighten the
screws evenly.
Guideline
Screw, handlebar
clamp
2
.
M6
10 Nm (7.4 lbf ft)
p. 22)
3
and take off the handlebar supports.
3
.
M10
40 Nm (29.5 lbf ft)
Change the handlebar if the handlebar is dam-
aged or bent.
M8
20 Nm
(14.8 lbf ft)
SETUP 2
Loctite
®
243™
5