EK-Quantum Vector2 Strix/TUF RTX 4080 D-RGB User Manual page 15

Gpu water block
Hide thumbs Also See for Vector2 Strix/TUF RTX 4080 D-RGB:
Table of Contents

Advertisement

STEP 2
M2.5 x 4 AX1 SCREW
Use seven (7) M2.5 x 4 AX1 Screws and PVC washers to tighten the
PCB on the water block. Tighten the screws evenly using the Phillips-
M2.5 PVC WASHER
head screwdriver. An additional one (1) M2.5 x 6 AX1 Screw must be
secured with an M2.5 Nut.
EK recommends you start tightening the screws around the GPU core
first, and then continuing outward to prevent damage to the GPU.
After attaching the water block, three (3) saved Factory provided
I/O Bracket screws can be reused.
For this step, you will need:
M2.5 x 4
M2.5 x 6
Factory provided
PVC Washer
AX1 Screw
AX1 Screw
I/O Bracket
M2.5 x 6 AX1 SCREW
(7 pcs)
(7 pcs)
(1 pc)
screw (3 pcs)
M2.5 NUT
FACTORY I/O BRACKET SCREWS
M 2.5 Nut
Phillips Head
(1 pc)
Screwdriver
Screws must be present in the places marked on the picture.
STEP 2
- 15 -

Advertisement

Table of Contents
loading
Need help?

Need help?

Do you have a question about the Vector2 Strix/TUF RTX 4080 D-RGB and is the answer not in the manual?

Table of Contents