Assembly - Husqvarna AutoTune 545RXT Operator's Manual

Introduction
WARNING:
product, you must read and understand the
safety chapter.
WARNING:
cable from the spark plug before you
assemble the product.
To attach the throttle handle
Note:
On some models, the throttle handle is attached
at the factory.
1. Remove the nut and screw at the bottom of the
throttle handle.
2. Put the throttle handle onto the right side of the
handlebar.
3. Align the screw hole in the throttle handle with the
hole in the handlebar.
4. Put the screw into the hole at the bottom of the
throttle handle, through the handlebar.
5. Put back and tighten the nut.
To assemble the handlebar
1. Remove the knob and attach the handlebar as given
in the illustration.
171 - 010 - 12.05.2022

Assembly

Before you assemble the
Remove the spark plug
2. Tighten the knob lightly.
3. Put on the harness and hang the product from the
suspension point.
4. Adjust the handle to put the product in a comfortable
work position.
5. Tighten the knob fully.
To set the handlebar in transport
position
1. Loosen the knob.
2. Turn the handlebar clockwise until the throttle handle
touches the battery.
3. Turn the handlebar around the shaft.
4. Tighten the knob.
To assemble the cutting equipment
The cutting equipment includes a cutting attachment and
a cutting attachment guard.
WARNING:
WARNING:
attachment guard that is recommended for
the cutting attachment. See
page 29 .
Use protective gloves.
Always use the cutting
Accessories on
11