Spare Parts And Accessories; Disposal; Ec Declaration Of Conformity - Stihl BGA 60 Instruction Manual

English
18.5 Temperature limits
WARNING
■ The battery is not protected against all ambi‐
ent conditions. If the battery is exposed to cer‐
tain environmental conditions, it may catch fire
or explode. This may result in serious injury to
people and damage to property.
► Do not charge the battery below -20°C or
above +50°C.
► Do not use the blower, battery or charger
below -20°C or above +50°C.
► Do not store the blower, battery or charger
below -20°C or above +70°C.
18.6 Recommended temperature
ranges
For optimum performance of the blower, battery
and charger, observe the following temperature
ranges:
– Charging: 5°C to 40°C
– Use: - 10 °C to + 40 °C
– Storage: - 20 °C to + 50 °C
If the battery is charged, used or stored outside
the recommended temperature ranges, perform‐
ance may be reduced.
If the battery is wet or moist, allow the battery to
dry for at least 48 h between 15°C and 50°C and
with less than 70% humidity. Higher humidity
may extend the drying time.
18.7 Sound Values and Vibration
Values
The K-value for sound pressure levels is 2 dB(A).
The K-value for sound power levels is 2 dB(A).
K-value for vibration level is 2 m/s².
– Sound pressure level L
to EN 50636-2-100: 76 dB(A).
– Sound power level L
in EN 50636-2-100: 89 dB(A).
– Vibration level a measured according to
hv
EN 50636-2-100, control handle: < 1.2 m/s².
The vibration levels indicated were measured
according to a standardized test method and can
be used as a basis for comparing electric power
tools. The vibration levels actually occurring may
vary from the values indicated, depending on the
type of application. The vibration levels indicated
can be used for an initial estimate of the vibration
stress. The actual vibration stress has to be esti‐
mated. The times when the electric power tool is
switched off and the times when it is switched on
34
measured according
p
measured as specified
wA

19 Spare Parts and Accessories

but running under no load can be taken into
account in the estimate.
For information on compliance with Employers'
Vibration Directive 2002/44/EC see
www.stihl.com/vib.
18.8 REACH
REACH is an EC regulation and stands for the
Registration, Evaluation, Authorisation and
Restriction of Chemical substances.
For information on compliance with the REACH
regulation see www.stihl.com/reach.
19 Spare Parts and Accesso‐
ries
19.1 Spare parts and accessories
These symbols indicate original STIHL
spare parts and original STIHL acces‐
sories.
STIHL recommends the use of original STIHL
spare parts and accessories.
Despite ongoing market observation, STIHL is
unable to judge the reliability, safety and suitabil‐
ity of other manufacturers' spare parts and
accessories; accordingly, STIHL cannot warrant
for the use of those parts.
Original STIHL spare parts and original STIHL
accessories are available from STIHL dealers.

20 Disposal

20.1 Disposal of Blower, Battery and
Charger
Contact the local authorities or your STIHL
dealer for information on disposal.
Improper disposal can be harmful to health and
pollute the environment.
► Take STIHL products including packaging to a
suitable collection point for recycling in accord‐
ance with local regulations.
► Do not dispose with domestic waste.
21 EC Declaration of Con‐
formity
21.1 STIHL BGA 60 Blower
ANDREAS STIHL AG & Co. KG
Badstraße 115
D-71336 Waiblingen
Germany
0458-008-9601-A