Advertisement
Quick Links
INSTALLER'S
GUIDE
ALL phases of this installation must comply with NATIONAL, STATE AND LOCAL CODES
Low Voltage Conduit
Entry Kit:
BAYLVKIT100A
IMPORTANT — This Document is customer property and is to remain with this unit. Please return to service information
pack upon completion of work.
Section 1. Safety Information
WARNING
s
s
SAFETY HAZARD!
by individuals possessing adequate backgrounds of electrical
and mechanical experience. Any attempt to repair a central air
conditioning product may result in personal injury and/or prop-
erty damage. The manufacturer or seller cannot be responsible
for the interpretation of this information, nor can it assume any
liability in connection with its use.
Section 2. General Information
The BAYLVKIT100A provides a metal enclosure
that can be mounted on the side of the air handler
for electrical conduit attachment.
Each kit will contain:
1 - Enclosure Assembly
4 - Screws
1 - Installer's Guide
This information is intended for use
18-GJ27D1-1A-EN
Fits Models:
Hyperion
ForeFront
Air Handlers
SAFETY HAZARD!
sharp edges on equipment or any cuts made on sheet metal
while installing or servicing. Personal injury may result.
WARNING
s
s
LIVE ELECTRICAL COMPONENTS!
stallation, testing, servicing, and troubleshooting of this prod-
uct, it may be necessary to work with live electrical compo-
nents. Failure to follow all electrical safety precautions when
exposed to live electrical components could result in death or
serious injury.
and
TM
TM
CAUTION
Sharp Edge Hazard. Be careful of
During in-
Advertisement
Related Manuals for Trane BAYLVKIT100A
Summary of Contents for Trane BAYLVKIT100A
- Page 1 Section 2. General Information The BAYLVKIT100A provides a metal enclosure that can be mounted on the side of the air handler for electrical conduit attachment. Each kit will contain:...
- Page 2 INSTALLER'S GUIDE Section 3. Installation Step 1 - Place the conduit entry kit enclosure as- sembly on the side of the air handler to determine mounting position and knock out option. Make sure the enclosure assembly cover flange is seated properly into the door notch. Note - The enclosure assembly flanges must rest on the air handler and the assembly must be slid towards the front of the air handler so it is resting...
- Page 3 INSTALLER'S GUIDE Step 4 - Attach the conduit to the low voltage conduit entry kit enclosure with a conduit nut. Step 5 - Remove the coil compartment front panel. Step 6 - Match the conduit bracket up to the marks made in step 2. Step 7 - Use the four provided screws to secure the conduit entry kit to the side of the air handler.
- Page 4 Step 11 - Replace the coil compartment front panel. About Trane and American Standard Heating and Air Conditioning Trane and American Standard create comfortable, energy efficient indoor environments for residential applications. For more information, please visit www.trane.com or www.americanstandardair.com The manufacturer has a policy of continuous data improvement and it reserves the right to change design and specifications without notice. We are committed to using environmentally conscious print practices.