Ethernet Port Leds - Emerson RSTi-EP CPE200 Series Quick Start Manual

Ethernet Port LEDs

The Ethernet Port LEDs are located in the PHY connector
•
itself. They are controlled by the PHY
There are two LEDs per port, one for Link/Speed ("LNK")
•
and one for Activity ("ACT")
Ethernet LinkSpeed ("LNK"):
•
o
o
o
per spec)
Ethernet Activity ("ACT"):
•
o
o
Figure 2: 3-Position Switch RUN EN/RUN DIS/STOP
5 RSTi-EP CPE200 Series Controllers Quick Start Guide
GREEN indicates 1 Gbps
AMBER indicates 100 Mbps
OFF indicates 10 Mbps (currently not supported
GREEN indicates Link
BLINKING GREEN indicates activity on the link
GFK-3109B