Continuity Test - VOLTCRAFT VC292 Operating Instructions Manual

12.14 Continuity test

Ensure that all objects that you want to measure (including circuit compo-
nents, circuits and component parts) are disconnected and discharged.
1. Switch the DMM on and select
2. Press the SEL/
The continuity test symbol and the Ω symbol will appear on the display.
Æ
3. Press the SEL/
again to switch to the next mode.
4. Insert the red test lead into the
Ω measurement socket and
the black test lead into the
COM"measurement socket.
If the measured resistance
Æ
is equal to or less than 10
Ω, the multimeter will beep
to indicate continuity. There
is no further beeping from
>100 Ω. The continuity test
measures resistances of up
to 600 Ω.
"OL" (overload) indicates
Æ
that the measurement range has been exceeded or that the circuit is broken.
5. After taking a measurement, remove the leads from the measured object and
switch the DMM off.
90
mode.
button once to switch to the mode.
button