D) Continuity Test ( ) - VOLTCRAFT 2446476 Operating Instructions Manual

d) Continuity test ( )

Make sure all circuit parts, circuits, components, and other objects of measurement
are disconnected from the voltage supply and fully discharged.
1. Set the function dial to
2. " "will show on the display.
3. Connect the test leads to the terminals:
- Red test lead to the
- Black test lead to the COM terminal.
4. Connect the test lead probes to the correct
test points in the circuit.
5. A resistance of ≤ 10 Ω is considered conti-
nuity, and a beep will sound.
- The measuring range is ≤ 200 Ω.
- "OL" will appear on the display if the
maximum range is exceeded or if the
circuit is open.
6. When finished measuring, disconnect the
test leads and switch the power OFF.
.
terminal.
45