Sd Card Life Detection Function - Pioneer VR6C-Z710DH Owner's Manual

When the
"Video Clip Length"
When the voltage drops to the voltage value set in
Parking Mode, and instead activates Security Mode.
When the voltage drops below the voltage value set in
the device operation is stopped (power is turned off).
When the
"Video Clip Length"
OFF
When the voltage drops to the set voltage value +0.1 V or lower, Security Mode is not activated and the
device operation is stopped (power is turned off).
Notes
• Using a commercially available tester, measure the vehicle's battery voltage while the engine is off,
and select a value that is the same or slightly lower than the measured voltage.
• The battery may already be low, and the voltage may have dropped. Additionally, voltage
measurement may give a higher reading immediately after turning off the engine. Please note that
the measured value may not be the actual value.
• If a tester is not available, please consult with a car dealer or specialist.
• The voltage detection may vary depending on the operating environment and vehicle conditions.

SD Card Life Detection Function

When a microSD card is installed, the buzzer of this product will beep and a message recommending
the replacement of microSD card will be displayed on the screen when it has reached a set number of
guaranteed writes.
This message will be displayed at regular intervals until the microSD card is replaced.→
and Ejecting the microSD Card"
setting is other than OFF, and the
"Voltage Monitoring"
setting is other than OFF, and the
00:10
The memory write limit may have
reached its limit. We recommend
replacing the SD card.
− 33 −
"Security Mode"
+0.1 V or lower, this stops
"Voltage Monitoring"
"Security Mode"
setting is ON
during Security Mode,
setting is
"Inserting