Table of Contents
Advertisement
Using a Locking Clip
You will rarely need to use a locking clip except in some
older vehicles. Built in child restraint locking systems have
been required in vehicles since 1996, and many vehicles
had these features even earlier.
Review pages 9-12 and your vehicle owner's manual to
determine if your vehicle belts require a locking clip. If you
need a locking clip immediately, they are likely available at
an auto dealership, an auto store, or where you purchased
this base.
You can call us at 1-800-951-4113 or text us at 1-812-
652-2525 for one.
A locking clip will not fix all types of seat belt problems. You
MUST
have a lap and shoulder belt to use a locking clip.
Follow pages 20-22 Warnings and Steps 1-4 before
starting locking clip installation.
1.
Determine Locking Clip
Location
Grasp both vehicle belts
together just behind the latch
plate to mark the position for
locking clip.
Unbuckle the belt.
NOTE:
If the latch plate ends up just at the belt path opening
so you cannot grasp the vehicle belt at the latch plate, grasp
the vehicle belts on the opposite side of the base, as close
to the latch plate as possible.
25
2.
Attach Locking Clip
Thread both portions of the
vehicle belt onto the locking
clip, as close to the latch
plate as possible.
3.
Position Locking Clip
Position locking clip about
1 in. (2.5 cm) from vehicle
belt's latch plate.
4.
Rebuckle Vehicle Belt
26
continued on next page
Advertisement
Table of Contents
