Installation - Miele KM 3010 Operating And Installation Instructions

Installation

Preparing the countertop
 Create the countertop cut-out. Re-
member to maintain the minimum
safety distances (see "Installation" –
"Safety distances").
 Seal any cut surfaces on wooden
countertops with a special varnish,
silicone rubber, or resin to prevent the
wood from swelling as a result of
moisture. The sealant must be tem-
perature-resistant.
Ensure that the sealant does not get
on the top surface of the countertop.
The sealing strip ensures that the
cooktop will sit securely in the cut-out
without slipping. Any gap between the
frame and countertop will become
smaller over time.
Installing the cooktop
 Attach the sealing strip provided un-
derneath the edge of the cooktop.
 Feed the cooktop power cord down
through the countertop cut-out.
 Place the cooktop in the center of the
cut-out. When doing this, make sure
that the seal of the appliance sits
flush with the countertop on all sides.
This is important to ensure an effec-
tive seal all round.
If during installation the seal around
the frame does not sit flush with the
countertop in the corners, the corner
radius (≤ R4) can be carefully filed
down to fit.
Do not use any additional sealant
(e.g., silicone) on the cooktop.
 Connect the cooktop to the power
supply (see "Installation – Electrical
connection").
 Connect the cooktop to the gas sup-
ply (see "Installation – Gas connec-
tion").
Installation
39