Whirlpool WFC682CLW Owner's Manual page 7

2. Place a broad, flat container beneath the drain pump filter to
collect the drain water. Release the black hose from the hose
clip, remove the plug, and drain the hose into the container.
Empty the container. Repeat this procedure if necessary until
all the water has drained. Make sure that the black hose is
completely dry, replace the plug, and secure the hose in the
clip.
NOTE: If water does not drain well, push in hose slightly to
remove any possible kinks.
Hose clip
3. Lay a cotton cloth beneath the drain pump filter to absorb any
water still in it. Then remove the drain pump filter by turning it
counterclockwise.
4. Check the drain pump filter once a month. Remove large
clumps of lint by hand from the filter and place lint in a suitable
waste container. Remove remaining residue from the filter by
rinsing with water.
Black hose
5. Reinsert the drain pump filter by turning it clockwise. Make
sure to turn it in as far as it will go, with the filter handle
remaining as close as possible to the vertical position.
6. Replace and close the dispenser drawer. Make sure to insert
both rails simultaneously when replacing the drawer. You will
hear a clicking sound that indicates the rails have engaged. To
ensure proper placement of the drawer, pull out fully. The
drawer should be fully engaged and the rails locked in placed.
Make sure the drain hose is secured in the hose clip and
tucked underneath the cutout.
Additional Cleaning
Gently pull back the rubber door seal and clean any stained areas,
soil buildup, or lint with the textured side of an affresh
Cleaning Wipe.
® Machine
7